Conditions for use of CNC lathes

Apr 03, 2025

Leave a message

The normal use of CNC lathes must meet the following conditions: the power supply voltage fluctuation at the location of the machine tool is small, the ambient temperature is lower than 30 degrees Celsius, and the relative temperature is less than 80%.

Environmental requirements
The location of the machine tool should be far away from the vibration source, and should avoid the influence of direct sunlight and heat radiation, and avoid the influence of moisture and airflow. If there is a vibration source near the machine tool, anti-vibration grooves should be set around the machine tool. Otherwise, it will directly affect the processing accuracy and stability of the machine tool, and will cause poor contact of electronic components, failure, and affect the reliability of the machine tool.

Power supply requirements
Generally, CNC lathes are installed in machining workshops. Not only do the ambient temperature change greatly and the use conditions are poor, but there are also many electromechanical equipment, resulting in large fluctuations in the power grid. Therefore, the location where the CNC lathe is installed requires strict control of the power supply voltage. The power supply voltage fluctuation must be within the allowable range and remain relatively stable. Otherwise, it will affect the normal operation of the CNC system.

Temperature conditions
The ambient temperature of the CNC lathe is lower than 30 degrees Celsius and the relative temperature is less than 80%. Generally speaking, exhaust fans or air coolers are installed inside CNC electric control boxes to keep the working temperature of electronic components, especially the central processing unit, constant or with little temperature difference. Excessive temperature and humidity will reduce the life of control system components and increase faults. The increase in temperature and humidity and the increase in dust will cause adhesion on the integrated circuit board and cause short circuits.

Standardized use of machine tools
When using machine tools, users are not allowed to arbitrarily change the parameters set by the manufacturer in the control system. The setting of these parameters is directly related to the dynamic characteristics of each component of the machine tool. Only the value of the gap compensation parameter can be adjusted according to the actual situation.

Users cannot replace machine tool accessories at will, such as using a hydraulic chuck that exceeds the specifications of the manual. When setting accessories, the manufacturer fully considers the matching of parameters in various links. Blind replacement causes mismatch of parameters in various links and even unexpected accidents.

Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!