How to install the tool for heavy cutting vertical lathe

Apr 09, 2025

Leave a message

1. Preparation before installation
‌Tool inspection‌
Confirm that the blade has no chipping, severe wear, and the tool handle has no deformation or cracks (the blade has four edges that can be used in reverse, and the direction needs to be adjusted with a hexagonal wrench).
Clean the tool handle conical surface and spindle taper hole, remove burrs and foreign matter.
‌System calibration‌

The radial runout of the spindle end face must be ≤0.01mm, and the axial runout must be ≤0.005mm (use a dial indicator to detect)
2. Tool installation steps
‌Tool handle locking‌
The taper handle tool must be aligned with the spindle The taper hole of the shaft fits perfectly, and the thread of the pull rod is tightened clockwise (in the same direction as the main shaft rotation)
The cutter head type tool must ensure that the blade edge angle number is in the same direction to reduce the end tooth runout 7
‌Tool tip positioning‌

The tool tip height should be the same as the workpiece axis, and the deviation is ≤0.02mm (too high will easily wear the back face, too low will easily break the edge)
Adjust the height by adding or removing shims, and use thick shims first to reduce the superposition error 38
‌Cutting direction correction‌

The tool bar axis should be perpendicular or parallel to the feed direction, and the main deflection angle should be set according to the processing requirements (rough 85°~90° for machining, 92°~94° for finishing)
Use a dial gauge to check the radial runout of the tool tip ≤0.03mm8
‌Locking specification‌

The clamping screws need to be tightened alternately and symmetrically, and the torque is set according to the tool specifications (usually the torque of the M12 screw is 45~50N·m)
Check that the fixed bevel at the bottom of the blade is completely in line with the tool body and then lock it
III. Accuracy verification and debugging
‌Test cutting verification‌

After light cutting test cutting, check the chip shape: long filaments flowing to one side indicate that the tool is installed skewed
The machining surface is out If vibration marks are present, check if the tool overhang is too long or the locking is insufficient
‌Dynamic compensation‌

If the blade is obviously worn on one side during heavy cutting, check the tool tip height and main deflection angle setting
When the machining accuracy is out of tolerance, adjust the shim combination first to avoid directly grinding the tool body
IV. Safety regulations
The tool overhang length is ≤ 1.5 times the tool bar thickness to prevent vibration caused by insufficient rigidity
When cutting solid workpieces, the main cutting edge must be strictly aligned, otherwise it is easy to cause the tool head to break
After installation, the tool swing amount needs to be tested in idle operation. Abnormal shaking requires immediate stop and adjustment

Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!